10.Fill: crankcase (with the specified amount of the recom- mended engine oil) Quantity Total amount 2.40 L (2.11 Imp qt, 2.54 US qt) Without oil filter cartridge replacement 2.00 L (1.76 Imp qt, 2.11 US qt) With oil filter cartridge replace- ment 2.10 L (1.85 Imp qt, 2.22 US qt) 11.Install: dipstick 12.Start the engine, warm it up for several min- utes, and then turn it off. 13.Check: engine (for engine oil leaks) 14.Check: engine oil level Refer to “CHECKING THE ENGINE OIL LEVEL”. 15.Check: engine oil pressure 1 MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Slightly loosen the oil gallery bolt 1 . b.
Start the engine and keep it idling until engine oil starts to seep from the oil gallery bolt. If no engine oil comes out after one minute, turn the engine off so that it will not seize. c. Check the engine oil passages, the oil filter cartridge and the oil pump for damage or leakage. Refer to “CRANKSHAFT AND OIL PUMP” in chapter 4. d. Start the engine after solving the problem(s) and check the engine oil pressure again. e. Tighten the oil gallery bolt to specification. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 3 - 36 CHANGING THE ENGINE OIL CHK ADJ T.R. Oil gallery bolt 10 Nm (1.0 m · kg, 7.2 ft · lb)