b. Loosen the water pump air bleed bolt 2 , without removing it, to allow all of the air to escape from the air bleed bolt hole. c. When coolant begins to flow out of the bolt hole, tighten the water pump air bleed bolt to specification. 2 d. Loosen the cylinder head air bleed bolt 3 , without removing it, to allow all of the air to escape from the air bleed bolt hole. e. When coolant begins to flow out of the bolt hole, tighten the cylinder head air bleed bolt to specification. 3 f. Install the V-belt cooling duct 2. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 15.Start the engine, warm it up for ten minutes, and then rev the engine five times.
16.Pour the recommended coolant into the radiator until it is full. 17.Stop the engine and allow it to cool. If the coolant level has dropped after the engine has cooled, add sufficient coolant until it reaches the top of the radiator, and then install the radiator cap. 18.Start the engine, and then check for coolant leakage. 19.Install: upper panel front carrier Refer to “FRONT CARRIER AND FRONT GUARD”. left side panel right side panel Refer to “SEAT AND SIDE PANELS”. 3 - 44 CHANGING THE COOLANT CHK ADJ T.R. Water pump air bleed bolt 10 Nm (1.0 m · kg, 7.2 ft · lb) T.R. Cylinder head air bleed bolt 10 Nm (1.0 m · kg, 7.2 ft · lb)