. SAFETY PRECAUTIONS FOR MAINTENANCE PRECAUTIONS FOR INSPECTION AND MAINTENANCE may so always explosion. available is being caps, then acid. Any mistake in handling may injury, explosion, or fire, so always battery, always wear protective goggles gets into your eyes, immediately wash starting switch OFF. Wait for disconnector switch to OFF 2 - 36 PRECAUTIONS WHEN WELDIN G Welding operations must al ways be performed by a qualified welder and in a place equi There is a hazard of gas, fir e, or electrocution when performing welding, so never allo to perform welding.
HANDLING BATTERY Before inspecting or handli ng the battery, turn the key i n the starting switch to OFF po When installing the optio nal battery disconnector switch, turn the battery disconnec For details, see "HANDL ING BATTERY DISCONNECTOR SWITCH (PAGE 6-43)" Danger of battery exploding When the battery is bein generated and may explo includes dilute sulphuric cause serious personal observe the following. Do not use or charge below LOWER LEV Always perform perio level, and add distill battery filler solution) Do not smoke or brin Hydrogen gas is ge charged, so remove t a well-ventilated pla perform the charging. After charging, tighten When the battery is bein generated and may explo de.
In addition, the battery includes dilute sulphuric cause serious personal observe the following. Do not use or charge EL mark. This will cause dic inspection of the battery ed water (or commercially After charging, tighten Do not smoke or brin Hydrogen gas is ge nerated when the battery he battery from the machine Danger from dilute sulphuri When the battery is bein generated and may explo includes dilute sulphuric cause serious personal observe the following. When handling the ba and rubber gloves.
If battery electrolyte g your eyes with large a medical attention imm If battery electrolyte g immediately with larg When the battery is bein generated and may explo includes dilute sulphuric cause serious personal If battery electrolyte g ets on your clothes or skin, Removing battery cables trical system or performing electrical welding, turn the st Before repairing the elec approx. 1 minute, then re For machines equipp position. For details, see "HAN Before repairing the elec approx. 1 minute, then re move the negative (-) batter y cable to stop the flow of elec ed with a battery disconnector switch, set the battery d DLING BATTERY DISCONNECTOR SWITCH (PAGE 6-4