侍# Some fault codes are not applied to this machine. 3-26 Fault code J1939 SPN J1939 FMI Reason Effect (only when fault code is active) 338 1267 3 Idle shutdown vehicle accessories relay driver circuit - Voltage above normal, or shorted to high source. Open circuit or short to voltage source detected at the idle shutdown vehicle accessory/ignition bus relay circuit. Vehicle accessories or ignition bus loads controlled by the idle shutdown relay will not power up. 339 1267 4 Idle shutdown vehicle accessories relay driver circuit - Voltage below normal, or shorted to low source. Low voltage detected at the idle shutdown vehicle accessory or ignition bus relay circuit when commanded ON.
Vehicle accessories or ignition bus loads controlled by the idle shutdown relay will not power up. 343 629 12 Engine control module warning internal hardware failure - Bad intelligent device or component. ECM power supply errors have been detected. Engine power derate. 346 630 12 Engine control module calibration memory software - Bad intelligent device or component. Invalid switch configuration adjustable parameter setting have been detected by the engine control module (ECM). Various optional switch inputs to the ECM may not operate correctly. 351 627 12 Injector power supply - Bad intelligent device or component. The ECM measured injector boost voltage is low. Engine power derate.
352 3509 4 Sensor supply 1 circuit - Voltage below normal, or shorted to low source. Low voltage detected at sensor supply number 1 circuit. Engine power derate. 383 729 5 Engine intake air heater 1 circuit - Current below normal or open circuit. A malfunctioning engine intake air heater circuit has been detected. Engine may not start or may be difficult to start. 386 3509 3 Sensor supply 1 circuit - Voltage above normal, or shorted to high source. High voltage detected at sensor supply number 1 circuit. Engine power derate. 415 100 1 Engine oil rifle pressure - Data valid but below normal operational range - Most severe level.
Oil pressure signal indicates oil pressure below the engine protection critical limit. Progressive power and/or speed derate increasing in severity from time of alert. If engine protection shutdown feature is enabled, engine will shut down 30 seconds after red stop lamp starts flashing. 418 97 15 Water in fuel indicator - Data valid but above normal operational range - Least severe level. water has been detected in the fuel filter. None on performance. 427 639 9 J1939 data link - Abnormal update rate. Communication between the engine control module (ECM) and another device on the SAE J1939 data link has been lost. Engine will only idle.
428 97 3 Water in fuel indicator sensor circuit - Voltage above normal, or shorted to high source. High voltage detected at the water in fuel circuit. None on performance. No water in fuel warning available. 435 100 2 Engine oil rifle pressure - Data erratic, intermittent, or incorrect. The engine oil pressure sensor is reading an erratic value. None on performance.