D1146/D1146TI/DE08TIS MAINTENANCE MANUAL 2.3. Engine Inspection 2.3.1. Stopping engine After checking the engine for any unusual condition at the idling speed, then turn the key switch to stop the engine. 2.3.2. General engine inspection cycle О : Check & adjust ● : Replace * ( О) The engine oil change interval is determine by engine use and oil grade. 2.3.3. Use of original parts for repair and replacement For engine is being mechanically harmonized with many parts, only when the original parts that the manufacture recommends to use is used, the engine trouble would be preventively maintained and capable to keep up the maximum performances.
For the analogous parts not the original parts are poor in qualities and gives illl performances, it may rather bring early engine failure. 32 Printed in Jan.
2001 PS-MMA0415-E1A Inspection Daily Inspection time(km) Remark 1,000 10,000 15,000 20,000 40,000 Cooling System Check for leakage(hoses, clamp) О Check the water level О Check the V-belt tension О Change the coolant water ● Lubrication System Check for leakage О Check the oil level gauge О Change the lubricating oil ● 1st (О) Replace the oil filter cartridge ● 1st (О) Intake & Exhaust System Check the leakage for intercooler (hoses, clamp) О Clean and change the air cleaner element О Fuel System Drain the water in separator О Clean the fuel strainer of fuel feed pump О Check the fuel line leakage О Check fuel Injection timing When necessary Replace the fuel filter cartridge ● Check the injection nozzles When necessary Engine Adjust Check the exhaust gas state О Check the battery charging О Check the compression pressure О When necessary Adjust Intake/Exhaust valve clearance When necessary