L7089 / L7189 5.1 Manual Test Mode The GSM Motorola L7189 is equipped with a manual test mode capability. This capability allows service personnel to take control of the unit, and by entering certain keypad commands, make the unit performs desired functions. To enter the manual test command mode, a GSM / DCS test sim (Part No 8102430Z04) must be used. The test sim is inserted into the SIM slot beneath the battery (See figure 6.1 ), the battery should then be re-inserted and the unit powered on. The # button should then be pressed for approximatly 3 second until ‘test’ appears on the display, and the correct commands must then be followed.
Figure 6.1 SIM Card insertion 5.2 Live Sim Card A SIM (Subscriber Identity module) card will be required to access the existing local GSM / DCS / PCS cellular network, or remote networks when travelling. (If the roaming agreement has been made with the provider.) The SIM card contains all the data necessary to access GSM services, and also: The ability to store user information such as phone numbers etc… All information required by the network provider to provide use to the network 5.3 Personality Transfer 5.3.1 Introduction Personality Transfers are required when a phone is Express Exchanged or when the main board is replaced.
The reason for personality transfers are to reproduce the customer’s original personalized details such as menu and stored memory such as phone books etc… or even just to program a unit with basic user information such as language selection. There are two possible methods of transferring this information from unit to unit, or with a master transfer, card to unit: - Normal Transfer is used when the customer’s original unit still powers up and as discussed above the customers personalized menu selections etc… are required to be transferred to the replacement unit.
Master Transfer is used when the faulty unit will not power up and the transfer is used to configure the replacement board to a set standard. Below is the procedure to set up a Master Transfer Card and to carry out each method of transfer correctly. 5.3.2 Normal Transfer 1. Insert transfer card into ‘Donor’ Unit. Turn unit on till ‘Clone’ appears. 2. Enter 021# to upload first block of data. ‘Please wait’ will be displayed. 3. Remove card. of 48 European Customer Services 22 SIM CARD