5-101.bk Page 10 Friday, March 17, 2006 11:05 AM Torque Specifications for Critical Fasteners (Cont.) a English threads. b V-MAC applications. Torque Specifications for Hose Clamps NOTE: The band of any hose clamp in all installations should be a minimum of 0.090 inch (2.290 mm) from the end of the hose and must be clear of tube bead.
Page 2-10 200 SPECIFICATIONS Description Torque Lb-Ft N•m V-MAC components (cont.) Lower support bracket-to-cylinder block capscrews Upper support bracket-to-injection pump capscrews Timing event marker (TEM) V-MAC 7-pin pump connector Bracket-to-block capscrews Hose clamp screw RPM/TDC (engine position) sensor (jam nut) MPH (road speed) sensor (jam nut) Engine oil pressure sensor Intake manifold temperature sensor Coolant temperature sensor Coolant level sensor Bulkhead connector (jackscrew) V-MAC module connector (jackscrew) V-MAC ELAB valve terminal nut Fuel injection pump actuator connector Electrical equipment panel mounting leg hardware Electrical equipment panel accessory studs Timing solenoid to Econovance (four bolts) 40 15 22 15 40 15 15 15 6 23 23 23 5 2 3 15 6 2 15 54 20 30 20 54 20 20 20 8 31 31 31 7 3 4 20 8 3 20 Water manifold screw Water pump cover-to-water pump housing screw Water pump shaft locknut Water pump-to-cylinder block screw 25 15 90 60 34 20 122 81 Hose Clamps Torque Lb-In N•m SAE J536 Type F Air inlet systems Water or coolant systems Oil drain systems 38 28 28 4 3 3 Hi-torque heavy-duty worm clamp 80 9 T-bolt type hose clamp 50 6