5-101.bk Page 9 Friday, March 17, 2006 11:05 AM [214 HD] AIR INLET MANIFOLD [215 NK] COOLANT MANIFOLD Refer to Figure 4-9. Refer to Figure 4-9. 1. Support the air inlet manifold sections and remove 12 capscrews (9) that secure the manifold sections (6 and 8) to the cylinder heads. 1. Support the coolant manifold sections and remove 12 capscrews (5) retaining the manifold sections (1 and 4) to the cylinder heads. 2. Remove air inlet manifold. It may be necessary to gently pry or tap the manifold lightly with a soft mallet to break the seal. 2. Remove manifold assembly. It may be necessary to pry or tap lightly with a soft mallet on the housing sections to break the seal. 3.
If the air inlet manifold is to be replaced, remove sensor (7) located on the inlet manifold (6), if installed. 3. If necessary, separate the two coolant manifold sections (1 and 4) by loosening two clamps (3) and removing the coupling (2). 2 3 4 3 1 6 7 5 8 9 200251a Figure 4-9 — Air Inlet Manifold Removal Page 4-9 200 ENGINE DISASSEMBLY 1. Coolant manifold, front section 2. Coupling 3. Clamp 4. Coolant manifold, rear section 5. Capscrew 6. Air inlet manifold, rear section 7. Sensor 8. Air inlet manifold, front section 9. Capscrew, 12-point