5-101.bk Page 27 Friday, March 17, 2006 11:05 AM [212 UC] FLYWHEEL Refer to Figure 4-34. 1. With engine stand rotated so that engine is inverted (crankshaft horizontal), loosen all six flywheel retaining capscrews. 2. Remove two of the flywheel retaining capscrews that are opposite each other. Install two longer capscrews or studs to allow flywheel to be safely removed from the crankshaft. 3. Remove remaining capscrews. 4. Carefully tap flywheel by alternating from side to side to work it off the aligning dowel pins. The flywheel is heavy. Lifting the flywheel will require the help of an assistant or the use of a suitable lifting device (J 25026-A or equivalent).
Attempting to lift a flywheel without such assistance may result in severe personal injury. Figure 4-34 — Flywheel Removal 5. Support the flywheel and remove two guide capscrews. 6. Using a suitable lifting device such as J 25026-A, or adequate assistance, remove flywheel. Remove flywheel timing pointer, if present, to avoid damaging the pointer during flywheel removal. Page 4-27 200 ENGINE DISASSEMBLY