1B-22 AIR CONDITIONING Condenser Assembly (Except 4HK1-TC Engine Model For Australia) N1A0199E Legend 1. Refrigerant line 4. Condenser assembly 2. Pressure switch 5. Refrigerant line fixing clamp 3. Receiver / drier Removal 4. Condenser assembly Preparation: Disconnect the battery ground cable. Discharge and recover refrigerant. 1. Pressure switch connector 2. Refrigerant line fixing clamp 3. Refrigerant Line Remove the radiator stay before condenser (GCC). Installation 1. Condenser Assembly If installing a new condenser, be sure to add 30cc (0.8 Imp fl oz) of new specified compressor oil to a new one. Use a back up wrench when disconnecting and re- connecting the refrigerant lines.
When removing the line, the connecting part should immediately be plugged or capped to pre- vent foreign matter from being mixed into the line. Tighten the condenser bolt to the specified torque. 2. Refrigerant Line Tighten the inlet line to the specified torque.