SAFETY PRECAUTIONS SECTION 2 Page 3 2.1. GENERAL WORK SAFETY – FOLLOW THESE RULES WARNING!: This symbol and text with bold letters is used throughout this manual to call your attention to instructions concerning personal safety. Observe and follow these instructions. Be certain anyone operating and service this machine is aware of these rules. Failure to follow these rules may result in injury or death. WARNING!: The machine can only be operated by a person who is familiar with this manual, knows operation of the machine and its mechanisms, experienced and properly licensed to operate such machines. Carefully observe and follow all instructions provided in this manual.
Human error is a contributing factor in most equipment-related injuries. Haste, carelessness and lack of training are the primary causes of injuries. Most operating injuries occur because of excessive speed, loss of control, failure to observe warning signs, slipping or falling while entering for dismounting, a lack of barms on roadways or piles, lack of a ROPS or seat belt, or not watching in the direction of travel. Most maintenance injuries occur during welding or when using hammers or wrenches. The most common faults are improper work position, a slipped tool, missed aim, a broken tool, flying chips and no welding hood. Think before you act.
A careful operator or maintenance man is the best insurance against an accident. Always wear proper safety equipment. Avoid wearing jewelry and loose fitting clothing; they could catch on moving parts, which could result in serious injury or death. Hard hat, sturdy rough-soled work shoes or safety shoes, ear protectors, reflective clothing, safety glasses and heavy gloves may be required. Consult your employer for specific safety equipment requirements. Each job site and application may have personal safety requirements.
Carefully evaluate your particular application and machine for equipment such as heater and defroster, all windshield wipers, warning lights, side view and rearview mirrors, back-up alarms, fire extinguisher, rotating beacons and additional lights. If in doubt, contact your distributor. The machine should be equipped with a fully charged fire extinguisher. All personnel should be instructed in proper usage. Recharge immediately after use. Do not jump on or off the machine. Keep two hands and one foot or two feet and one hand in contact with the steps and grab handles and rails at all times. Place objects on machine from ground level before mounting machine.
Electrical system is 24-volt negative ground. When charging battery or starting using booster battery always use the receptacle socket on the left side of engine. When using jumper cables, precautions must be taken to minimize chances of injury or damage to electrical parts. DRESSTA TD-20H