SAFETY PRECAUTIONS SECTION 2 Page 7 2.3. OPERATION A machine's weight and the vibration it creates can cause the edge of a high wall to collapse. Keep your machine back from the edges of banks and excavations. Travel slowly in congested areas or on rough ground, slopes or near drop-offs or on snow, ice or slippery surfaces. Maintain a safe distance between your machine and other vehicles according to the condition of the road and load. Never hold the hydraulic controls in their extreme position after the equipment has reached its maximum travel. This could cause overheating of the hydraulic system. Never use the blade as a brake except in an emergency.
Do not adjust the seat position while the machine is in motion. A loss of control may result. Completely stop the machine, apply and lock the parking brake and then adjust the seat. Carry the blade low for maximum stability and visibility. Where noise exposure exceeds levels defined by proper health and safety authorities and applicable standards wear authorized ear protective equipment. 2.4. MAINTENANCE Authorized personnel only is allowed to maintain or repair a machine. It is forbidden to allow unauthorized person to control the machine. Do not hasten. It may cause accident. Put objects onto machine standing on the ground level before you climb on machine.
When service or maintenance requires access to areas that cannot be reached from the ground, use a ladder or platform. If such ladders or platforms are not available, use the machine hand holds and steps provided. Perform all service or maintenance carefully. Loosen the radiator cap slowly to relieve all pressure in the system and use caution when removing the caps. Loosen the filler cap slowly to relieve the pressure to prevent possible injury. Always vent the hydraulic system before working on any hydraulic component. Have all equipment resting on the ground or blocking before removing any hydraulic component. Never work beneath the blade without proper blocking.
Improper blocking could result in serious injuries. Do not attempt to make repairs that you do not understand. Consult you distributor. Use only approved parts for repairs and maintenance show in your parts catalog. Failure to do so could compromise your personal safety and machine performance and reliability. Do not attempt to repair a protective structure after an accident. Repaired structures do not provide the original strength and protection. Contact your distributor for information on structure replacement. Do not operate the machine again until the ROPS has been replaced. Do not cut, grind, weld, drill or tap holes in the ROPS.
This could weaken the structure, or affect the overall energy absorption capabilities. DRESSTA TD-20H