4 THROTTLE 4.4 Throttle Cable Replacement 1 Raise the boom arms, engage the boom supports a shut off the engine. nd WARNING Never work under the boom arms without the boo supports engaged. m 2 Remove the seat and hydrostatic shield.(fig. C355 3 Remove the tee handle, nut and washer holding th assembly in place. 4 Open the rear door and unhook the throttle rod en from the throttle pivot assembly.(fig. C3567) 5 Pull the throttle cable out toward the front of the loader. (fig. C3570) 6 Remove the rod end left on the old throttle control cable and transfer it to the new control cable. 7 Replace the throttle control cable in the reverse or of above.
Adjust the lock nut and tighten against the L seat support on the underside of the deck. 8 Adjust the rod end on the throttle cable to obtain f travel.(fig. C3570) NOTE: The throttle rod may need to be adjusted to ensure contact of the engine lever and the limiter bolts highflow speed settings (up and down). (fig. C3567) 7) e d der .H. ull for Seat assembly Hydrostatic Shield C3557 C3557 C3878 C3878 Pivot Assembly Throttle End Limiter Stops C3567 Throttle Cable C3570 C3570 4-18