TROUBLESHOOTING / Diagnosing Procedure 5. Perform troubleshooting CAUTION: Do not disconnect harnesses or hydraulic lines while the engine is running. The machine may malfunction or pressurized oil may spout, possibly resulting in personal injury. Stop the engine before disconnecting harnesses or hydraulic lines. Perform diagnosis by connecting Palm to the machine or by using the service menu of monitor unit. In case any fault code has been displayed by diagnosis by using Dr. ZX (the service menu of monitor unit), check the cause of the trouble by referring to Troubleshooting A in this section. In case any fault code has been displayed by diag- nosis by using Dr.
ZX (the service menu of moni- tor unit), write the fault code. Delete the fault code once and retry self-diagnosis again. If the fault code is displayed again, check the cause of the trouble by referring to Troubleshooting A in this section. After the machine trouble has been cor- rected, the fault code (displayed by the service menu of monitor unit) will be deleted. Therefore, in case the problems which are not easily re-predicable are encountered, check the fault code by using Dr. ZX. In case the fault code is not displayed, check operating condition of each component by refer- ring to Troubleshooting B in this section and by using Dr. ZX (the service menu of monitor unit).
T107-07-01-005 T107-07-01-006 NOTE: Note that the fault codes displayed do not necessarily indicate machine trouble. The controller stores even temporary electrical malfunctions, such as a drop in battery output voltage or disconnections of the switches, sensors, etc., for inspections. For this reason, the “RETRIAL” is required to erase the accumulated fault codes from the controller memory and to confirm if any fault codes are indicated after the “RETRIAL”. T107-07-01-007 T5-1-4