FCA 2022 Chassis Cab — PARKVIEW REAR BACK UP CAMERA

STARTING AND OPERATING 157 NOTE: Manual Activation Of The Rear View Camera: NOTE: When enabled the system operates above 37­mph (60­km/h) and below 112­mph (180­km/h). If the vehicle speed remains below 8­mph (13­km/h), the Rear View Camera image will be displayed continuously until deactivated via the touchscreen button X, the transmission is shifted into PARK, or the ignition is placed in the OFF position. Use of the turn signal suppresses the warnings. 1. Press the Controls button located on the bottom of the Uconnect display.

The system will not apply torque to the steering wheel whenever a safety system engages (Anti-Lock Brakes, Traction Control System, Electronic Stability Control, Forward Collision Warning, etc.). PARKVIEW REAR BACK UP CAMERA 2. Press the Back Up Camera icon to turn the Rear View Camera system on. When the vehicle is shifted out of REVERSE with camera delay turned off, the rear camera mode is exited and the previous screen appears. When the vehicle is shifted out of REVERSE with camera delay turned on, the camera image will continue to be displayed for up to 10 seconds unless the following conditions occur:

The vehicle speed exceeds 8­mph (13­km/h), the vehicle is shifted into PARK, the vehicle’s ignition is placed in the OFF position, or the user presses image defeat X to exit out of the camera video display. The touchscreen button X to disable display of the camera image is made available ONLY when the vehicle is not in REVERSE. Cargo Camera Icons — If Equipped 4 The ParkView Rear Back Up Camera allows you to see an on-screen image of the rear surroundings of your vehicle whenever the gear selector is put into REVERSE. The image will be displayed on the Uconnect display along with a caution note to “Check Entire Surroundings” across the top of the screen.

After five seconds this note will disappear. The ParkView Camera is located in the center of the tailgate handle. Back Up Camera Touchscreen Button Cargo Camera Touchscreen Button Whenever the Rear View Camera image is activated through the Back Up Camera button in the Controls menu, and the vehicle speed is greater than, or equal to, 8­mph (13­km/h), a display timer for the image is initiated. The image will continue to be displayed until the display timer exceeds 10 seconds. AUX Camera Touchscreen Button NOTE: For the 3500, 4500, and 5500 Chassis Cab vehicles, the Rear Back Up Camera is shipped loose and not installed. Please refer to the Ram Body Builder’s Guide for more information.

If equipped with a Cargo Camera, a touchscreen button is made available to indicate the current active Camera image being displayed whenever the Rear View Camera image is displayed.