STARTING AND OPERATING 159 For information on Auxiliary Cameras (if equipped), see Ъ page166. SURROUND VIEW CAMERA SYSTEM — IF EQUIPPED Press this button on the touchscreen to enter the Surround View Camera menu in the Uconnect system. When the vehicle is shifted into REVERSE, the Rear View and Top View is the default view of the system. Your vehicle may be equipped with the Surround View Camera system that allows you to see an on-screen image of the surroundings and Top View of your vehicle whenever the gear selector is put into REVERSE or manually activated via the Uconnect system. The Top View of the vehicle will show which doors are open.
The image will be displayed on the touchscreen display along with a caution note “Check Entire Surroundings” across the top of the screen. After five seconds, this note will disappear. The Surround View Camera system is comprised of three sequential cameras located in the front grille and side mirrors, in addition to a fourth Rear Back Up Camera. If the camera delay is turned on, the camera image will display for up to 10 seconds after shifting out of REVERSE. The camera image will not display for 10 seconds if the vehicle speed exceeds 8mph (13km/h), the vehicle is shifted into PARK, or the ignition is placed in the OFF position.
The X button on the touchscreen disables the display of the camera image. Modes Of Operation Standard Rear View can be manually activated by selecting “Back Up Camera” through the Controls menu within the Uconnect system. Top View 4 The Top View will show in the Uconnect system with Rear View and Front View in a split screen display. There are integrated ParkSense arcs in the image at the front and rear of the vehicle. The arcs will change color from yellow to red corresponding the distance zones to the oncoming object. If the camera delay is turned off, the camera image will close and display the previous screen after shifting out of REVERSE.
If active guidelines are enabled, the lines are overlaid on the image in the Rear View to illustrate the width of the vehicle. The view will also include the side view mirrors and its projected back up path based on the steering wheel position. The fifth button of the ParkSense Camera View screen will change based on the features present in the vehicle. If not equipped with a Cargo Camera or Trailer Reverse Guidance, the Back Up Camera soft button will be displayed. If equipped with a Cargo Camera but no Trailer Reverse Guidance, the Cargo Camera soft button will be displayed.
If equipped with both a Cargo Camera and Trailer Reverse Guidance, the Cargo/Trailer Reverse Guidance soft button will be displayed. NOTE: For the 3500, 4500, and 5500 Chassis Cab vehicles, the Rear Back Up Camera is shipped loose and not installed. Please refer to the Ram Body Builder’s Guide for more information. There are different colored zones to indicate the distance to the rear of the vehicle. Refer to the chart below: The Surround View Camera system has programmable settings that may be selected through the Uconnect system Ъ page189. Yellow 1ft - 6.5ft (30 cm - 2m) Green 6.5ft or greater (2m or greater) Zone Distance To The Rear Of The Vehicle Red 0 - 1ft (0 - 30 cm)