16 GETTING TO KNOW YOUR VEHICLE The vehicle’s horn will rapidly chirp three times along with a single flash of the vehicle’s exterior lights. 1. Remove the emergency key (1) by pushing and holding the release button (2) located on the side of the key fob while pulling the emergency key out with your other hand. 3. Next, locate the gap on the right side of the key fob, which is positioned further to the edge than the left side gap. Pry open the right side, and remove the back cover. NOTE: The doors have to be open and then closed in order for the vehicle to check for the presence of a key fob; the Key Left Vehicle feature will not activate until all of the doors are closed. 4.
Remove the battery by using a suitable tool, such as a screwdriver, to slide the battery downward and back toward the key ring. These alerts will not be activated in situations where the vehicle’s engine is left running with the key fob inside. Replacing The Battery In The Key Fob The replacement battery model is one CR2032 battery. Emergency Key Removal NOTE: Customers are recommended to use a battery obtained from Mopar®. Aftermarket coin battery dimensions may not meet the original OEM coin battery dimensions. 1 — Emergency Key 2 — Emergency Key Release Button Key Fob Battery Location Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/ perchlorate for further information. 2. Hold the key fob with the button side facing down, and locate the small rectangular gap on the left side between the housing and the back cover of the key fob. Use a small screwdriver (or similar tool) to pry open the left side of the fob cover while applying pressure until the cover snaps open. NOTE: When replacing the battery, ensure the (+) sign on the battery is facing upward. Avoid touching the new battery with your fingers. Skin oils may cause battery deterioration. If you touch a battery, clean it with rubbing alcohol.
Do not touch the battery terminals that are on the back housing or the printed circuit board.