180 STARTING AND OPERATING functionality. The following exterior lights will remain on for the entirety of the sequence: Ignition in ACC or RUN Park/Running Lamps Remote start is inactive Brakes are not applied Side Marker Lamps (if equipped) Left turn signal is not applied License Lamp Signature Lamp (if equipped) Right turn signal not applied Hazard switch is not applied Low Beams Fog Lamps (if equipped) The sequence will cancel if any of the following conditions occur:
Seven-Pin Connector Daytime Running Lamps Brakes are applied 1 — Backup Lamps 2 — Running Lamps 3 — Left Stop/Turn 4 — Ground 5 — Battery 6 — Right Stop/Turn 7 — Electric Brakes During this time the following lights will sequence, each activating for three seconds: Vehicle is shifted from PARK Vehicle is no longer stationary 1. Brake and CHMSL (third brake light) 2. Left turn signal Left turn signal activated from stalk 3. Right turn signal Right turn signal is activated from stalk Hazard switch is activated 4. Reverse Lamps 5. High Beam Any button on the key fob is pushed Ignition button is pushed Trailer Light Check This light check sequence will continue for a total of five minutes.
High Beam stalk position is changed This feature will run the trailer lights through a sequence to check the trailer light function. It is available in the instrument cluster under the Trailer Tow menu Ъ page85. The sequence will only activate if the following conditions are met: Sequence is canceled in the instrument cluster T OWING T IPS Vehicle is equipped with the Trailer Tow Package Before setting out on a trip, practice turning, stopping, and backing up the trailer in an area located away from heavy traffic.
When activated the feature will enable all of the exterior lights sequentially for up to five minutes allowing time to walk around and verify Vehicle is in PARK Vehicle is not in motion