NOTICE After cleaning the element, shine a light from the inside and check if any small holes or thin parts are found on the element. If such parts are found, replace the element. When cleaning the element, do not hit it against anything. Do not use any element if its folds, gasket or seal are damaged. 4. Install the cleaned element, then install cover 0. REPLACE INNER ELEMENT After removing the cover and outer element, remove the inner element. 1. 2. Cover the air connector (outlet port) with a clean cloth or cloth tape to prevent dirt from getting in. 3. Clean the inside of the body, then remove the cover installed in Step 2. 4.
Install a new inner element to the connector, then tighten the nuts. Do not clean the inner element and use it again. 5. Install the outer element and cover. 6. After replacing the element, return the red piston in the dust indicator to its original position. 3-27