11 10 9 8 7 6 5 4 3 2 1 EBU18070 Engine stop switch “ENG. STOP” Set this switch to “RUN” before starting the engine. The engine stop switch controls the ignition and stops the engine when it is running. Use this switch to stop the engine in an emergency situation. The engine will not start or run when this switch is set to “OFF”. 1. Light switch “LIGHTS” 2. Engine stop switch “ENG. STOP” EBU18061 Handlebar switches 2 1 4-2 EBU18280 Throttle lever Once the engine is running, movement of the throt- tle lever will increase the engine speed. Regulate the speed of the ATV by varying the throttle position.
Because the throttle is spring- loaded, the ATV will decelerate, and the engine will return to an idle any time the hand is removed from the throttle lever. Do not use the headlights with the engine turned off for an extended period of time, oth- erwise the battery may discharge to the point that the starter motor will not operate properly. If this should happen, remove the battery and recharge it. CAUTION: ECB00040 EBU18140 Light switch “LIGHTS” Set this switch to “LO” to turn on the low beams and the taillight. Set the switch to “HI” to turn on the high beams and the taillight. Set the switch to “OFF” to turn off all the lights.