6. WIPER AND WASHER CIRCUIT 6.
WIPER AND WASHER CIRCUIT 1) OPERATING FLOW OPERATING FLOW Start switch ON Fuse box (No.13) RDU membrance controller [CN-376 (1)] Fuse box (No.7) I/conn [CN-5 (18)] I/conn [CN-17 (5)] Wiper motor controller [CN-141 (7)] Wiper motor [CN-21 (4)] Fuse box (No.19) I/conn [CN-5 (16)] l/conn [CN-17 (4)] Wiper motor controller [CN-141 (6)] Wiper pump [CN-22 (2)] (1) (2) Wiper switch ON Wiper switch ON (Intermittent) Wiper switch ON [CN-376 (12)] I/conn [CN-5 (20)] I/conn [CN-17 (8)] Wiper motor controller [CN-141 (10) 供 (3)] Wiper motor [CN-21 (6)] Intermittently operating (3) Wiper switch ON Wiper switch ON (continual) Wiper switch ON [CN-376 (3)] I/conn[CN-5 (15)] I/conn[CN-17 (2)] Wiper motor controller [CN-141 (2) 供 (4)] Wiper motor [CN-21 (2)] Continual operating (4) Washer switch ON Washer switch ON Washer switch ON [CN-376 (11)] I/conn [CN-5 (17)] I/conn [CN-17 (7)] Wiper motor controller [CN-141 (9) 供 (8)] I/conn [CN-17 (6)] I/conn [CN-5 (19)] Washer pump [CN-22 (1)] Washer operating Wiper switch ON [CN-376 (3)] I/conn[CN-5 (15)] I/conn[CN-17 (2)] Wiper motor controller [CN-141 (2) 供 (4)] Wiper motor [CN-21 (2)] Continual operating (5) Auto parking Auto parking (when switch OFF) Switch OFF [CN-376 (3)] Wiper motor parking position by wiper motor controller CHECK POINT CHECK POINT 3) 侍 # GND :
Ground 4-16 Engine Start switch Check point Voltage STOP ON 刮 - GND (fuse box) 刯 - GND (switch power input) 20~25V 到 - GND (switch power output) 刱 - GND (wiper switch power input) 0 ~ 5V 刲 - GND (wiper power output) 24V 刳 - GND (wiper motor) 0 or 24V