. OPERATION EXPLANATION OF COMPONENTS room the Ambient temperature Lighting time Above -4 ° C 0 seconds -4 ° C to -15 ° C 5 seconds to 30 seconds Below -15 ° C 30 seconds (C): START position This is the engine-start position. Keep the key at this position during cranking. Immediately after starting the engine, release the key. It will automatically return to the ON position (B). (D): HEAT position Set to this position when starting the engine manually in cold weather. When turning the key to the HEAT position (D), the engine preheating pilot lamp lights up. As the key returns automatically to the OFF position (A) when released, immediately turn to the START position (C) to start the engine.
Hold the key in the HEAT position (D) within 5 to 30 seconds only. REMARK When turning the key to B (ON) position at cold seasons, engine pre-heating starts automatically. As the necessity of automatic pre-heating is judged by the outdoor air temperature, starting the engine is sometimes difficult if the engine is colder than the outdoor temperature. Only in such case, turn the key to D (HEAT) position and manually preheat. 3 - 36 STARTING SWIT Starting switch ( 1) is u sed t o start or stop the e ngine (A): OF F positio The key can be system stopped withdrawn. Switches for lamp electrical ngine is turned off (B): ON position Electric current fl ows t hroug h the charging and lamp circuits.
Keep starting switch k ey in ON po sition while the engine is running. In c old weather, if the starti ng switch is turned to the ON position (B), preheating is autom atically started the engine p reheatin g pilot lamp lights up . A fter the preheatin g is completed, the engine prehea ting pilot lamp g oes out. The tim e that the engine pr eheating pilot lamp stays lighted up depends on the ambient te mperature as show n in the table below.