4 Remove cotter pins and clevis Remove screws for cable clamp C4290 4-12 FOOT PEDALS 4.2 Cable Replacement 137/153 Check cable ends, eyelets or rod ends, and mounting pins for wear before removing the cable. Replace worn parts when replacing new cables. Cable ends should be inspect- ed every 150 hours of operation. 1 Raise the boom arms, engage the boom supports and shut off the engine. WARNING Never work under the boom arms without the boom supports engaged. 2 Remove the seat and hydrostatic shield. 3 Remove the bolts connecting the cable to the cross shaft Assy. (fig. C4287b) 4 Remove the screws retaining the cable clamp to the frame. (fig. C4289) 5.
Remove the screws retaining the cable clamps to the valve mount (fig.C4290) 6. Remove the cotter pins from the valve end of the cables and remove the clevis pins. (fig. C4290) 7 Remove the cable. 8 Remove the clevis and eyelet ends of the cable and reuse them if still serviceable. 9 Install the new cable in the reverse order above. There must be a minimum of 3/8’’ (6mm) of thread engagement into the cable clevis and eyelet ends. Note: After installation of a new cable, the foot pedal angle will need to be verified and adjusted if necessary. Refer to page 4-14 ~4-15.