When normal No. Input mode and condition Display 0 Power source monitor (with starting switch ON) Lights up H mode 1-1 I I 0 Power mode S mode I- II L mode I L 0 Enoine speed signal monitor (when engine is running) Flashes Heavy-duty operation mode \ \ @ Working mode General operation mode 7 c Finishing operation mode -1 --\ Lifting operation mode 1-t \ * The combinations given in the table above are displayed according to the input mode and machine condition. * Engine speed signal monitor (3) flashes according to the engine speed. (At 2000 rpm, it flashes approx. 20 times/l 0 set) * When switching the input, the following display is given.
When electric PCZOO-5, -5 MIGHTY I_1 When switching input Display on (0.5 set) PC220-5 \_ PC22OLC5 . -\ power is switched PC2OOLC-5, -5 MIGHTY . 1 Hi \\ Switching travel .I_\. I speed Lo :_ 33 Auto-deceleration switch !I-: .I-: Work equipment control lever n I .I-. \ Swing lock switch \_ I- .I-\.3 Swing control lever Service control lever The display is given for 0.5 - 1.5 set after the input is Travel lever t-1 1: .r .a switched. Power max. button \ I l-l .I_( 3’ - 42 -