173 173 MOTOR SHIFT/DIFF HYDROSTATIC BEGINS WITH REF NO. 1. _ 2, 3. 4, 5, 6. _7. B. 9. 10. 11. 12, 13. 14, 15. 16. 17. 1B. 19, 20. 21. 22, 23. 24. 25. PART NUMBER 157-246 214-491 499-446 306-885 106-385 106-566 154-252 515-249 154-316 515-716 154-743 154-220 515-174 117-611 154-726 154-230 154-226 105-003 110-333. 154-296 154-411 154-344 159-643 154-326 157-899 154-221 159-218 QTY 1 2 2 2 1 1 2 1 1 1 17 2 1 1 1 1 1 1 1 1 1 1 — - S/N LOCK HYDRAULICS 5X0710.
DESCRIPTION MANIFOLD (2-SP) COIL, 12V SOLENOID (3 WAY-2 POS VALVE) MOUNT PLATE FLG LOCKNUT (M6-1.00) SCREW (M6-1.00 X 70mm)_ CONNECTOR (04S-04090) HOSE (040FX-26"-3000) RUN TEE (04S-040-040) _ HOSE (O060FX90-42”-3000) HOSE (040FX90S-23"-3000) CONNECTOR (040-065) _ HOSE (040FX90-74"-3000) ABRASION SLEEVE (1.00” x 22") HOSE (040FX90-15"-3000). BRANCH TEE (06S$-040-040) CONNECTOR (040-06S90) FLG LOCKNUT (5/16-NC) _ BOLT-ON CLAMP (1") CAP (O40F) CONNECTOR (045-060) | UN RU TEE (060FX-060-060) TEE (08N-060-060 X 2.375") CAP (O60F) = | HOSE (060FX90S-11"-3000) CONNECTOR (06S-060) HYD. MANIFOLD (4-PORT) _ REMARKS SEE FOOTNOTE 2 ~ SEE FOOTNOTE 3 SEE FOOTNOTE1 SEE FOOTNOTE 1 FOOTNOTES| 1.
#105-003 & #110-333 ATTACH TO STUD BOLTS ON FRAME PLATE. 2. EARLY PRODUCTION MANIFOLDS HAVE A CAVITY PLUG WHERE THE RELIEF VALVE WAS LOCATED. 3. WHEN “FRAME TILT” OPTION IS USED TWO MOUNT PLATES (306-885) IS REQUIRED, ONE ON EITHER SIDE OF FRAME. WITH NO FRAME TILT ONLY ONE MOUNT PLATE (306-885) IS USED ON OUTSIDE OF FRAME. NOTE REFER TO O-RING CHART (800-301) IN BACK OF THE BOOK FOR REPLACEMENT OF O-RINGS. | 808-809