OM7007 Radio / CD Player - Section 70 Page 70-5 USING THE RADIO SCAN: Press SCAN/PSCAN and release to scan all stations on the band that are being used. When a strong enough frequency is found, the radio will play for 8 seconds before continuing to scan. To end the scan, press SCAN/PSCAN again. The radio will beep and display SCAN plus the frequency. Finding a Station BAND/AUTO: Press this button to switch between FM1, FM2, AM and WX. TUNE: To tune the radio manually, press the up/ down button once to tune to the next higher or lower station, one frequency at a time. PSCAN: Press and hold SCAN/PSCAN for more than 2 seconds to scan the presets on the band being used.
When a strong enough frequency is found, the radio will play that station for 8 seconds and then continue scanning. The display will show PSCN, the frequency, preset number and the current band. Preset scan will continue until the SCAN/ PSCAN button is pressed again. SEEK: Press the or button once to tune to the next available station. The SEEK mode ends once it reaches a tunable station. If either the or button is pushed while the radio is finding a station, the tuner will stop at the fre- quency tuned at the time the button was pressed. If SEEK does not find a tunable station, it displays NO STATION FOUND.
The radio remembers the sta- tion that was tuned when SEEK was initiated and goes back to that frequency if SEEK is cancelled. The audio mutes during the SEEK UP/DOWN pro- cess. Setting the Presets The six numbered buttons allows six favorite presets to be stored per band and easily return to them with the touch of a button. To set the presets: 1. Turn the receiver on. 2. Select the band. To cancel SEEK: 3. Tune to the desired station. Switch modes including: power off, ignition off, switch to CD, Radio, MP3, WMA, USB, AUX or iPod 4. Press and hold one of the 6 numbered buttons for more than 2 seconds to store the selected station.
During the 2-second set time, the radio will be muted and the preset number will be dis- played. When the preset station has been set, a beep will sound, then the audio and selected preset number will return. Change bands Press SCAN/PSCAN button Press any preset button 5. Repeat steps 1-4 for each button. Disconnect battery Press and hold SCAN/PSCAN button Pressing a preset button in the future will tune the radio to the station previously set on the band cur- rently in use. Press and hold BAND/AUTO button AUTO STORE : AUTO STORE temporarily stores the 6 strongest stations onto pushbuttons 1-6. Press and hold the BAND/AUTO button for more than 2 sec- onds.
A beep will sound and AUTO STORE will appear on the display until all of the presets have been saved in the band. AS will be displayed while AUTO STORE is active. Pressing BAND/AUTO will not affect the other bands. For example: if BAND/ AUTO is pressed while listening to FM1, the presets on AM, FM2, and WX will not change. Pressing and holding BAND/AUTO again will cancel AUTO STORE, and the original presets will be restored.