LUBRICANT SPECIFICATIONS Fuller Transmission Lubrication Lubrication Change and Inspection Off-Highway Use Fuller transmissions are designed so that the internal parts operate in a bath of oil circulated by the motion of gears and shafts. Grey iron parts have built-in channels where needed to help lubricate bearings and shafts. All parts will be amply lubricated if these procedures are closely followed: Refer to the Eaton Fuller transmission manual for servicing information. Highway Use Refer to the Eaton Fuller transmission manual for servicing information. Refer to the oil change vs. temperature chart that follows for special oil change information.
The “intermittent peak temperature” is the maximum temperature observed for a short time in a fully loaded vehicle performing normally. 1. Maintain oil level; check it regularly. CAUTION 2. Change oil regularly. Exceeding the recommended oil change intervals may be harmful to the life of the transmission and the transmission oil cooler. 5 3. Use the correct grade and type of oil. 4. Buy oil from a reputable dealer. 5-48 Y53-6077-1B1 (03/17)