2. CONNECTING THE TESTER TO THE ELECTRONIC 2.3 CONNECTING THE PORTABLE COMPUTER WITH 2.3 CONNECTING THE PORTABLE COMPUTER WITH “EDS” SOFTWARE TO THE TRANSMISSION CONTROL UNIT AND INFOCENTER 2 6 4 3 5 1 F0059430 2.3.1 CONNECTION TO THE TRANSMISSION CONTROL UNIT 1 - Connect the lead numbered “9141” of the interface cable (1) to the serial port of the portable computer (2). 2 - Join the connector marked “Powershift Agrotron 4.70 – 6.45” (3) of the Wilbar cable (4) (Wilbar KA 96-0529) to the four-pin connector (5) of the interface cable (1). 3 - Join the connector (6) of cable (4) to the connector X18 located internally of the right hand side console.
4 - With the portable computer switched on and the EDS program running, insert the starter key and turn to the “ I ” (ON) position. 2.3.2 CONNECTION TO THE INFOCENTER 1 - Connect the lead marked “EIC” of the interface cable (1) to the serial port of the portable computer (2). 2 - Join the connector marked “Infocenter” (3) of the Wilbar cable (4) (Wilbar KA 96-0529) to the two-pin connector (7) of the interface cable (1). 3 - Join the connector (6) of cable (4) to the connector X18 located internally of the right hand side console. 4 - With the portable computer switched on and the EDS program running, insert the starter key and turn to the “ I ” (ON) position. 20-11