SAFETY - Cab Tilting Raising the Cab antennae when you tilt the cab. Check for obstructions overhead (branches, power lines, lights, etc.) and in front (walls, work benches, other vehicles, etc.). 4. Place the control valve handle in the "Raise" position. Handle in "Raise" Position. 5. Attach pump handle to the pump and pump to raise the cab (the latch hooks will release automatically when pump is actuated). 1 WARNING Tilt the cab by using the equipment provided on the vehicle or by a hoist with sufficient capacity. Tilting the cab with an improvised prop is an unsafe practice. Failure to use the proper cab tilting equipment may lead to death or personal injury.
WARNING Always ensure the locking safety bar is fully engaged before getting under a fully tilted cab. Failure to engage the locking bar may result in the cab falling which may result in death or personal injury. WARNING CAUTION DO NOT tamper with any component of the cab tilt system. The hydraulic hoses, tilt cylinders and velocity fuses should be serviced by an authorized service center. Failure to comply may result in death or personal injury in the event the cab falls due to improper service of the tilt system. Remove heavy items and secure any loose items inside the cab before tilting the cab. Heavy items can damage the tilt mechanism and loose items can damage equipment inside the cab.
The following cab tilting instructions are labelled and installed on the base of the companion seat: 1. Park the vehicle on a level surface and turn the tires straight forward. 2. Secure or remove all loose items in the cab. Close all doors. 3. Check the clearance above and ahead of the cab. Ensure there will be enough room to clear roof NOTE In case of oil loss in the system or a lockup in the tilt cylinders, refer to the maintenance manual for repair instruc- tions. Y53-6096-1C1 (09/20) 15