ENGINE MAINTENANCE - Maintenance Procedures 4. Press the clips (1) and dismount the centrifugal oil filter element from the centrifuge base. Removing Full-flow Oil Filter 1. Install the new full-flow oil filter element into the oil module. 2 Removing Centrifugal Oil Filter Installing Full-flow Oil Filter 1 1 2 WARNING Lubricating oil can cause skin irritation or skin injury. To prevent skin injury, avoid unnecessary contact with the lu- bricating oil. Wear protective clothing, eye wear and gloves when handling lubricating oil. Failure to comply may result in personal injury. 5. Remove the O-rings from the screw cap and centrifuge base. 6. Turn the lower cap ј turn to release the cap. 7.
Remove the O-ring from the lower cap. 8. Remove the full-flow oil filter from the oil module. 2. Using engine oil, lightly lubricate the new O-ring for the lower cap. 3. Install the new O-ring onto the lower cap. 4. Tighten the lower cap ј turn to lock the full-flow oil filter in place. Oil Filter Installation Procedure for installing oil filter on PACCAR MX-11 engines. Use the following procedure to install oil filters. 54 Y53-1166-1G1 (08/2018)