ENGINE MAINTENANCE - Maintenance Procedures Module on page 56 before proceeding with disassembling the unit. Follow the steps below to disassemble the CCV to access to the replaceable filter and gaskets. 1. Lay the CCV module on a clean table with the engine interface facing down. 2. Unscrew the four bolts (1) using a ratchet with 10 mm socket. 1. Housing 2. Motor 3. Mounting Flange 3. Remove the motor from the housing and take out the filter. housing, and wipe the two gasket grooves with a clean, lint-free rag. 5. Properly dispose of the filter and gaskets. 2 Do not remove the retaining ring e-clip from the shaft. The e-clip (1) being slanted is OK (2).
How to Reassemble a CCV Unit Reassembly instructions for servicable Crankcase Ventilation (CCV) modules CCV Retainer Ring Installation Follow the steps below to reassemble the CCV after the old filter and gaskets have been removed. CCV Filter/Motor Installation 1 1 2 3 2 4. Remove the gasket from the motor as well as the gasket from the 58 Y53-1166-1G1 (08/2018)