Carburetor/Carburetor When checking float level and float drop, measure to float body, not seam. 9. Turn carburetor and check float setting using straightedge. Adjust floats so that they are even with edge of bowl or no more than 1 mm (0.04 in.) beyond edge. Bend float tab (A) to adjust. M36974 -UN-25JAN90 M36975 -UN-25JAN90 Turn carburetor and hold pivot pin in place. Check float setting using a straightedge. Adjust floats so that they are even with the edge of bowl or no more than 1 mm (0.04 in.) beyond edge. Bend float tang (A) to adjust.
T260 Engine B43E, B43G, B48G, P218G, or P220G M98,2050K,33 -19-11FEB87 CTM2 (19APR90) 50-14 16, 18, 20 & 24HP Onan Engines AllTractorManuals.com 130495 10. Turn carburetor right side up and measure float drop. The distance from top of carburetor body to top of float must be at least 5 mm (0.20 in.). Bend float arm (A) to adjust. If float drop is adjusted, check float level again. -UN-25JAN90 M36983 T260 Engine -UN-25JAN90 M36984 B43,E, B43G, B48G, P218G, or P220G M98,2050K,34 -19-02FEB87 50 14