Operating AutoPowr Transmission Adjusting Set Speeds A CAUTION: Avoid unexpected rapid acceleration. Check and adjust set speeds before putting tractor in motion. RXA0068281 —UN—27AUG03 Turn key switch to position. (For tractors with righthand reverser, engine must be running.) Move lever (A) to Scroll position. The forward and reverse set speeds will scroll on the corner post display (B) pausing at each speed for two seconds. Bar graph (C) indicates approximate set speeds for each forward and reverse speed band.
LeftHand Reverser Shown Adjust each speed when it displays by rotating the set speed adjuster on the speed control lever forward to increase the set speed value or rearward to decrease it. NOTE: Set speed adjustments may affect the corresponding set speed of the opposite direction. (See ADJUSTING REVERSEFORWARD SET SPEED RATIO in this section.) C MPH km/h C RXA0080540 —UN—09AUG05 A A—LeftHand Reverser B—Display C—Bar Graph B Corner Post Display OURX935,00004B8 1927AUG081/2 The set speed of a selected speed band and the ground speed of the tractor can be adjusted while the tractor is moving by rotating set speed adjuster (B). Increasing set speed value will increase ground speed.
Decreasing set speed value will decrease ground speed. New set speed will indicate on display (A). MPH km/h RXA0080543 —UN—29APR05 The maximum ground speed of a selected speed band is attained at full throttle when speed control lever (C) is pushed all the way forward to end of slot of the respective speed band. A A A—Display B—Set Speed Adjuster C—Speed Control Lever Corner Post Display C B RXA0080648 —UN—04MAY05 RightHand Reverser Shown OURX935,00004B8 1927AUG082/2 424 122208 PN=101