OPERATING THE MACHINE 20. OPERATING THE MACHINE 20.1 PREPARING THE WORK EQUIPMENT 20.1.1 SELECTING A WORK UNIT Refer to chapter "7. Equipment" for information on the work units registered. 20.1.2 PICKING UP THE WORK UNIT (EXCEPT MULTI-PURPOSE BUCKET) Connect the multi-purpose bucket as described in section „Pick- ing up the multi-purpose bucket“ (see next page). 1 - Make sure that the change-over lever for the additional con- trol unit is in position '2' (fig. 75_160). 2 - Start the engine. 3 - Unlock the quick-change unit by setting the control lever for special equipment into position ‘1’ (fig. 75_042). 4 - Lift the boom slightly by setting the multi-function lever into position ‘H’ (fig.
75_016). 5 - Tilt the quick-change unit slightly to the front by setting the multi-function lever into position 'A' (fig. 75_016). 6 - Drive the machine to the work unit until the quick-change unit (3) is below the pickup hooks of the work unit. Then, lift the boom until the work unit catches the quick-change unit (fig. 75_280). 7 - Tip in the quick-change unit until the work unit is connected to the limit stops on the the quick-change unit by setting the multi-function lever into position ‘E’ (fig. 75_016). 8 - Lock the quick-change unit by setting the control lever for special equipment into position ‘2’ (fig. 75_042). The interlocking pins (4) will then be visible (fig. 75_280).
2 1 75_160 3 2 0 1 75_042 3 4 75_280 90 75 016 _