105 Maintenance Section Differential and Final Drive Oil Level - Check i01102280 Differential and Final Drive Oil Level - Check SMCS Code: 3278-535-FLV; 4011-535-FLV Note: Before you measure the oil level, operate the machine for a few minutes in order to equalize the oil level. 1. Park the machine on level ground. Lower the bucket and apply slight downward pressure. Engage the parking brake. Stop the engine. g00287531 Illustration 155 Typical Example Rear Axle Note: The axle housings are equipped with magnetic drain plugs. 1. Remove drain plugs (2). Allow the oil to drain into a suitable container. 2. Clean the drain plugs and install the drain plugs. 3.
Wipe off dipstick/fill plugs (1) and the surfaces around dipstick/fill plugs (1). g00285312 Illustration 156 4. Remove the dipstick/fill plugs. Fill the axles with oil. Front Axle Reference: Refer to Operation and Maintenance Manual, “Capacities (Refill)” for the type of lubricant and for the refill capacity. 5. Clean the dipstick/fill plugs and install the dipstick/fill plugs. 6. Run the machine on level ground for a few minutes in order to equalize the oil level in the axle. Check the oil level in the axle. Reference: Refer to Operation and Maintenance Manual, “Differential and Final Drive Oil Level - Check” for the correct procedure. g00287527 Illustration 157 Rear Axle