SAFE OPERATION Allow the tractor time to cool off before working on or near the engine, muffler, radiator and so on. Do not remove radiator cap while the coolant is hot. When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely. If the tractor has a coolant recovery tank, add coolant or water to the tank, not the radiator. (See Checking coolant level on page 113.) Always stop the engine before refueling. Avoid spills and overfilling. Use only approved fuels. Always use grounded refueling facilities. Do not smoke when working around the battery or when refueling.
Keep all sparks and flames away from battery and fuel tank. The battery presents an explosive hazard because it gives off hydrogen and oxygen especially when recharging. Before “jump-starting” a dead battery, read and follow all of the instructions. (See JUMP STARTING on page 46.) Keep first aid kit and fire extinguisher handy at all times. Disconnect the battery's ground cable before working on or near electric components. To avoid the possibility of battery explosion, do not use or charge the refillable type battery if the fluid level is below the [LOWER] (lower limit level) mark.
Check the fluid level regularly and add distilled water as required so that the fluid level is between the [UPPER] and [LOWER] levels. To avoid sparks from an accidental short circuit, always disconnect the battery's ground cable (-) first and reconnect it last. (1) PTO shaft cover (2) PTO shaft cap (A) “NORMAL POSITION” (B) “RAISED POSITION” Before installing or using PTO driven equipment, read the manufacturer's manual and review the safety labels attached to the equipment. When operating stationary PTO driven equipment, always apply both of the tractor's parking brakes and place chocks behind and in front of the rear wheels. Stay clear of all rotating parts.
Never step over rotating parts. USING 3-POINT HITCH Use the 3-point hitch only with equipment designed for the appropriate category of 3-point hitch usage. When using a 3-point hitch mounted implement, be sure to install the proper counterbalance weight on the front of the tractor. To avoid injury from separation: Do not extend the lift rod beyond the groove on the threaded rod. (1) Battery Do not attempt to mount a tire on a rim. This should be done by a qualified person with the proper equipment. Always maintain the correct tire pressure. Do not inflate tires above the recommended pressure shown in the operator's manual.
(1) Groove SERVICING THE TRACTOR Before servicing the tractor, park it on a firm, flat and level surface, set both parking brakes, lower all implements to the ground, place the gear shift lever in neutral, stop the engine and remove the key. M5091,M5111 11