CONTROLS - Guide to the Warning Symbols The Stability Control Icon (ESC or Electronic Stability Control) illuminates during the power-on self test when the ignition is turned ON. It turns off after a few seconds if no system problems are detected. If a problem is detected, the ESC Warning lamp will turn on and stay on. Illuminates when the ESC system is regulating individual wheel brakes to correct the vehicle’s direction of travel. (Refer to Advanced ABS with Stability Control for more information.) detected, the ATC warning lamp will turn on and stay on. Illuminates when the ATC is regulating wheel spin and turns off after the traction control event has ended.
Flashes continuously when the ATC/ Deep Snow & Mud switch is turned on, indicating that this feature is active. dealer. Failure to comply may result in death, personal injury, equipment or property damage. 3 NOTE For more information about the stabili- ty control system installed on your ve- hicle, please refer to additional materi- al supplied with this operator manual, included in your glove box information- al packet. WARNING If this chassis is equipped with an electronic stability control (ESC) and is modified (e.g.
adding or removing an axle, converting from a truck to a trac- tor, converting from a tractor to a truck, changing the body, lengthening of the wheelbase and/or frame, relocating frame components, or modifying pneu- matic or electrical ABS/ESC harness- es) the ESC must be disabled by a qualified technician. If you have any questions, contact your authorized dealer. Failure to comply may result in death, personal injury, equipment or property damage. WARNING Axle, Traction Control If this chassis is equipped with an electronic stability control (ESC) and is modified (e.g.
adding or removing an axle, converting from a truck to a trac- tor, converting from a tractor to a truck, changing the body, lengthening of the wheelbase and/or frame, relocating frame components, or modifying pneu- matic or electrical ABS/ESC harness- es) the ESC must be disabled by a qualified technician. If you have any questions, contact your authorized Monitors wheel speed for poor traction. If a wheel begins to slip due to poor traction, it may reduce engine power or apply brakes in an effort to regain traction. Illuminates during the power-on self-test when the ignition is turned ON. It turns off after a few seconds if no system problems are detected.
If an ATC problem is 78 Y53-6047-2HEN (03/18)