Scania engines engine warranty for industrial engines 3. Any warranted part which is scheduled for replacement as required maintenance in Sca- nia's written instructions for maintenance and use of the engine by owner shall be war- ranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled re- placement, the part shall be repaired or re- placed by the engine manufacturer according to Subsection (4) below. Any such part re- paired or replaced under warranty shall be warranted for the remainder of the period prior to the first scheduled replacement point for the part.
shall not be liable under this article to war- rant failures of warranted parts caused by the use of a non-exempted add-on or modified part. 11. The Executive Officer of the California Air Resources Board may request, and in such case, the engine manufacturer shall provide, any documents which describe that manufac- turer's warranty procedures or policies. Parts covered by the Warranty The following is a list of parts considered to be part of the Emission Control Systems covered by the Emission Warranty for Scania industrial en- gines which were built to conform to federal and California emission control regulations: 4.
Repair or replacement of any warranted part under the warranty provisions of this article shall be performed at no charge to the owner at a warranty station. 5. Notwithstanding the provisions of Subsec- tion (4) above, warranty services or repairs shall be provided at all manufacturer distri- bution centers that are franchised to serve the subject engines. 1. Fuel injection system. 2. Air induction system. 3. Exhaust manifold system. 6. The owner shall not be charged for diagnos- tic labor that leadsto the determination that a warranted part is in fact defective, provided that such diagnostic work is performed at a warranty station. 4. Smoke puff limiter (included in ECU). 5. Oil filler cap.
6. EGR system (when applicable): a) Cooler. b) EGR valve. 7. The engine manufacturer shall be liable for damages to other engine components proxi- mately caused by a failure under warranty of any warranted part. 7. Exhaust brake (when applicable). 8. NOx sensors: a) NOx sensor, engine out. b) NOx sensor, tail pipe. 8. Throughout the engine's warranty period de- fined above, the engine manufacturer shall maintain a supply of warranted parts suffi- cient to meet the expected demand for such parts. 9. DOC (when applicable). 10. SCR system: a) DEF tank. b) DEF tank level, temperature and quality sensors. c) DEF hose. d) DEF injector. e) DEF injector pressure and temperature sensors.
f) Evaporator. g) SCR catalyst inlet temperature sensor. h) SCR catalyst including the ammonia-slip catalyst. i) SCR control unit (EEC3). 9. Any replacement part, as defined in Section 1900(b), Title 13 of the California Code of Regulations, may be used in the performance of any maintenance or repairs and must be provided without charge to the owner. It is not necessary for replacement parts to be the same brand or by the same manufacturer as the original part sold with the engine. Such use shall not reduce the warranty obligations of the engine manufacturer. 10.
Add-on or modified parts, as defined in Sec- tion 1900(b), Title 13 of the California Code of Regulations, that are not exempted by the California Air Resources Board may not be used. The use of any non-exempted add-on or modified parts shall be grounds for disal- lowing a warranty claim made in accordance with this article. The engine manufacturer OPM 100 en-GB 13 © Scania CV AB 2015, Sweden