OWNER 爷 S MANUAL JAC HEAVY DUTY TRUCK SEAT BELTS (3-Point Type) Adjusting Your Seat Belt To Fasten Your Belt You should place the belt as low as possible on your hips, not on your waist. If To fasten your seat belt, pull it out of the retractor and insert the metal tab into located too high on your body, the chances of sliding out from under it and the buckle. There will be an audible "click,, when the tab locks into the buckle. The seat belt automatically adjusts to the proper length only after the lap belt suffering serious injury or death are increased. Both arms should not be under or over the belt.
Rather, one should be over and the other under, as shown in is adjusted manually so that it fits snugly around your hips. If you lean forward the illustration. in a slow, easy motion, the belt will extend and let you move around. If there is a sudden stop or impact, however, the belt will lock into position. It will also lock if you try to lean forward too quickly. Check to make sure the belt is properly locked and that the belt is not twisted. NOTE: If the driver's seat belt is not fastened when the ignition key Is in the "ON" posi 鄄 To Release the Seat Belt tion, the seat belt warning light will flash. The seat belt is released by pressing the release button in the locking buckle.
When it is released, the belt should automatically draw back into the retractor. If this does not happen, check the belt to be sure it is not twisted, then try it a 鄄 gain. 14 15