TROUBLES AND ACTIONS OPERATION TOWING THE MACHINE 0. When towing the machine, use a wire rope that has ample strength for the weight of the machine that is being towed. Do not apply a sudden load to the wire rope. If the machine sinks in mud and cannot get out under its own power, or if the drawbar pull of the excavator is being used to tow a heavy object, use a wire rope as shown in the diagram on the right. Places pieces of wood between the wire ropes and the body to prevent the wire ropes from damaging the body. SEVERE JOB CONDITION 0. Never carry out any operation where the sensor goes under water. If the sensor should go under water, check the actuation of the automatic stop.
If there is any abnormality, please contact your Komatsu distributor for repairs. When digging in water, if the water gets on to the work equipment mounting pins, add grease to bucket links (A), (B), (C), (D) and (E) for each operation. When carrying out heavy duty digging and deep digging operations, add grease to bucket links (A), (B), (C), (D) and (E) (total: 5 points) before each operation. After greasing, operate the bucket several times, then add grease again. 3-98 WARNING WARNING