Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-86 Measure the drive shaft end clearance. Use dial indicator assembly, Part No. 3376050 with ex- tension, Part No. ST-537-4, and a magnetic base, Part No. 3377399. Hydraulic Pump Drive Shaft End Clearance mm in 0.076 MIN 0.0030 0.635 MAX 0.0250 Use a new gasket and install the hydraulic pump, if equipped, or the cover plate. Install the two mounting capscrews (M10-1.50 x 20) and tighten. Torque Value: 27 [20 ft-lb] Accessory Drive Assembly - Installation Install two guide pins, Part No. 3376488, in the accessory drive mounting capscrew holes of the gear housing.
Use a new gasket and install the accessory drive assem- bly. NOTE: Make sure the "V" stamped on the accessory drive gear is in the 9 o’clock position, so it will easily align with the camshaft idler gear when it is installed. The capscrew lo- cated in the lower corner nearest the cylinder block (1) must be installed with a new copper sealing washer and sealant, Part No. 3375068 or equivalent, applied to the threads. Install the five capscrews (M10-1.50 x 40) and plain wash- ers, and one capscrew (M10-1.50 x 35) with copper washer and tighten. Torque Value: 47 [35 ft-lb]