Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-91 Supports one, four and seven are doweled. The supports must align with the dowel pins in the cylinder block. Install the cam follower assemblies on the studs. Loosen the two installation tool cam follower retaining screws and remove the service tool. Install the washers and nuts on each stud. Tighten nuts on supports (1), (4) and (7) only. Torque Value: 47 [35 ft-lb] NOTE: The side clearance must be adjusted before the remaining nuts are tightened. Install a 0.76 mm [0.030 inch] feeler gauge between the number seven lever and the number three support.
Push the number three support toward the number four sup- port. Tighten the number three support nut. Torque Value: 47 [35 ft-lb] Install a 0.76 mm [0.030 inch] feeler gauge between the number four lever and the number two support. Push the number two support toward the number three support. Tighten the number two support nut. Torque Value: 47 [35 ft-lb] Measure the side clearance between the number one support and the number one lever. Cam Follower Side Clearance Between Supports mm in 0.76 MIN 0.030