Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-108 Tighten the gear cover capscrews in the sequence shown. For capscrews 1 through 22: Torque Value: 20 [15 ft-lb] For capscrews 23 through 28: Torque Value: 68 [50 ft-lb] Automatic Belt Tensioner - Installation Install the tensioner with a (M10-1.50 x 70) capscrew. Align the cast locator pin on the tensioner with the hole in the bracket before tightening. Torque Value: 43 [32 ft-lb] Front Crankshaft Oil Seal - Installation The capscrew hole spacing on the oil seal is not sym- metrical.
The gear cover, oil seal, and carrier gasket are each marked with an arrow located at approximately the 3 o’clock location. The clamping ring is marked with four punch marks which locate at approximately the 11:30 o’clock location. The oil seal must be installed with the lip of the seal and the crankshaft clean and dry . The yellow dust lip of the seal must be facing out. Align the arrow markings on the seal and gasket to the arrow markings on the gear cover. Use the installation sleeve provided in the new seal kit to install the new seal and gasket.