Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-117 Use clean 15W-40 oil to lubricate the o-rings. Press the connector all the way into the front housing by hand. When installing the front housing, be sure the oil con- nector and o-ring are in position to be pushed into the rear housing. Install the front Jacobs W Engine Brake housing on the front rocker lever supports. Center the oil connector between the front and rear hous- ings before tightening the capscrews. Tighten the capscrews in the sequence shown. Torque Value: 81 60 ft-lb] Overhead - Adjustment This procedure describes the valve and injector adjust- ment procedures for CELECT™engines.
The crankshaft rotation is clockwise when viewed from the front of the engine. The cylinders are numbered from the front gear housing end of the engine. The engine firing order is 1-5-3-6-2-4.