Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-124 NOTE: Care must be used when matching connectors with sensors. Each sensor has its own unique connection. Lubricate the sensor harness wire connectors with lithium grease. Connect the correct sensor harness wire connectors to the following sensors: oil temperature sensor (1), oil pressure sensor (2), engine position sensor (3). Connect the sensor and actuator harnesses together with Weather Pack connector (4). Jacobs W Brake Housing Spacer - Installation If the engine is equipped with Jacobs W Engine Brakes, apply a bead of sealant, Part No.
3823494 or equivalent, to the top of the rocker lever housing. Install the spacer using 18 capscrews (M8-1.25 x 25) and washers provided with the Jacobs W Brakes. Tighten the capscrews in the sequence shown. Torque Value: 25 [18 ft-lb] Install and tighten the oil supply hose fitting to the front brake housing. NOTE: Install the oil supply hose to the lubricating oil filter head after the filter head is installed. Install the Jacobs W terminal lead outs in the spacer. Connect the two solenoid electrical wires to the terminals on the inside of the spacer.