Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-140 Install a new sealing ring and the boost pressure sensor and the intake manifold temperature sensor. Torque Value: 27 [20 ft-lb] Install the correct sensor harness wire connectors to the sensors. Use a new gasket and install the air connection to the intake manifold. Use four capscrews (M10-1.50 x 22). Torque Value: 41 [30 ft-lb] Turbocharger Drain Fitting - Installation Apply a film of pipe sealant, Part No. 3375066, to the threads of the drain fitting. Install and tighten the fitting into the cylinder block. Insert the flexible turbo oil drain tube behind the filter head and install on the fitting.
Install the clamp and capscrew. Turbocharger - Installation Install a new gasket on the exhaust manifold. Apply a film of high temperature anti-seize compound to the turbocharger mounting studs. Install the turbocharger and four mounting nuts. Torque Value: 61 [45 ft-lb]