Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-142 Thermostat Housing - Installation Install the thermostat into the housing. Install a new seal in the groove on the thermostat housing mounting surface. Install the thermostat housing with four capscrews (M10- 1.50 x 145). Torque Value: 54 [40 ft-lb] Evenly space the bypass hose on the water pump and thermostat housing connections. Tighten the hose clamps. Torque Value: 3 [30 in-lb] Alternator - Installation NOTE: Do not tighten any of the capscrews and nuts to their final torque value until the alternator belt is installed and adjusted.
Install the alternator with one (1/2-20 x 6.0) capscrew (1) and a (1/2 x 20) nut (2) with washer. Install the adjusting link to the thermostat housing with one (M12-1.75 x 30) capscrew (3). Install the adjusting screw retainer (4) and capscrew (5) through the adjusting link and alternator mounting sup- port. Install the (1/2-13 x 5.75) adjusting screw (6) into the adjusting link (1). Install a (1/2 x 13) locknut (7) on the adjusting screw (6). Install the adjusting screw (6) into the retainer (4).