Section 3 - Rocker Levers - Group 03 Rocker Levers - General Information M11 Page 3-5 Rocker Levers - General Information The rocker lever group consists of the rocker lever assembly, rocker lever housing, rocker housing cover, and the crankcase breather. The rocker levers contain replaceable bushings. Both the intake and exhaust rocker levers contain blind rivets to plug the oil drilling holes in the levers. The rocker lever pad on the intake and exhaust rocker lever is precision ground and must not be repaired. Rocker Lever Assembly - Cleaning and Inspection for Reuse (3-01) Disassembly Label the rocker lever shaft assemblies ‘‘front’’ and ‘‘rear’’ when they are removed from the engine.
Label the rocker levers and supports with their relative position to each other as they are removed from the shafts. The rocker lever assemblies must be installed in the same position they were removed from. Remove the rocker shaft capscrews (1) and retaining clamps (2). Lift the shaft and levers out of the supports (3). Remove the rocker levers (4) from both shaft assemblies. Remove the locknut and adjusting screw from each rocker lever.