Section 3 - Rocker Levers - Group 03 Rocker Lever Bushing - Replacement (3-03) M11 Page 3-13 Use clean 15W-40 oil to lubricate both rocker lever shafts. Install the front end support on each shaft. Install the retaining blocks and support mounting capscrews through the end supports. Install the rocker levers on the front rocker lever shaft in the correct sequence as shown. NOTE: The rocker levers must be installed so they will be in the same position in the engine as when they were removed. Install one of the two shaft center supports on the shaft. Install the center support capscrew.
Install the remaining levers and supports with the intake (I) and the exhaust (E) valve rocker levers in the correct position as shown. Install the support mounting capscrews. Use the same procedure to install the rocker levers and supports on the rear shaft. Rocker Lever Bushing - Replacement (3-03) Disassembly Install the rocker lever in an arbor press. Use rocker lever bushing mandrel (1), Part No. ST-1284, and a support (2) to push the bushing out of the rocker lever.