Cam Follower Lever Socket - Replacement (Roller Removed) (4-05) Section 4 - Cam Follower Assembly - Group 04 M11 Page 4-18 Cam Follower Lever Socket - Replace- ment (Roller Removed) (4-05) Disassembly Install the cam follower lever in an arbor press, as shown. Press the socket from the lever. NOTE: If a socket is replaced, the mating push rod must also be replaced. Use solvent to clean the cam follower lever. Dry with compressed air. Use compressed air to blow any debris from the oil passages. Inspection Measure the inside diameter of the cam follower lever socket bore. Socket Bore I.D.
mm in 19.024 MIN 0.7490 19.050 MAX 0.7500 If the cam follower lever socket bore does not meet the specifications. The lever must be replaced. Measure the outside diameter of the new cam follower lever socket. Socket O.D. mm in 19.062 MIN 0.7505 19.088 MAX 0.7515